Tap

TAP

It is a good idea for beginners to try to tap first whorl are sized. This is done to avoid the occurrence of a broken tap, and feel how to make thread. Let us think a hole in the sheet steel strip soft in the nine-millimeter M tap ten. Plate in the drill eight comma five millimeter and in the vise jaws. Tap on hold with the key holder and a little lubricant, and then tap the appropriate inclusion and played clockwise with a little pressure to start the reduction.

No longer will feel quite hard and this must be played back for about half a lap to make the reduction. So next, little by little until the whole thorough. To ensure the thread is created is good, tap can be played continuously until near the end of the thread. may also be able to tap all the way, but sometimes there are holes for a small plate or a thick always stoppage. In this case, the tap should be excluded from the first hole and cleaned. tap should be cleaned before stored in the box.